Announcement

Collapse
No announcement yet.

Stand alone wiring harness

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Stand alone wiring harness

    The guy doing my harness sent me a link to some progress

    Basic back story-
    I found him on a Miata swap thread and the lfx. Sent him an email.
    He replied with a phone number and we spoke for 30 kin. He knew what he was up against and up for the challenge. He doesn't do things everyone else does.
    Talked to a local buddy that put a 6.2L in a jeep and turns out it's the same guy he used!

    Mitch sent me an email saying he needed some parts so I mailed him the throttle body, fuel pressure sensor from the fuel rail and the pedal. Finally had to find and get a pcm to him.
    Pcm hit his door today so I'm hoping its all done in a week or so!

    https://www.youtube.com/watch?v=if1M...ature=youtu.be

    I'll update this thread as things progress
    Custom installation in a 1964 Lotus 7. Www.exportedafrican.com

  • #2
    nice, watched a couple of his videos, seems like a cool dude. What's he charging you?
    2000 S10 2wd ext cab getting an LTG A8 swap

    2016 1LT RS, 2.0T A8
    13.462 @ 100.65, stock eng/tune w/ some weight reduction

    12.957 @ 103.45, JacFab BigMouth TB & Charge pipe, Catless downpipe, LSD diff swap, Ghetto drag pack, unfinished tune.

    Comment


    • #3
      Will see when its all done but initial discussion was $300 or so. Plus parts etc
      Custom installation in a 1964 Lotus 7. Www.exportedafrican.com

      Comment


      • #4
        Doesn't seem bad, but I guess it depends on how much the parts total ended up being? Saw his new video of it finished the other day while I was binge watching youtube at home sick.
        2000 S10 2wd ext cab getting an LTG A8 swap

        2016 1LT RS, 2.0T A8
        13.462 @ 100.65, stock eng/tune w/ some weight reduction

        12.957 @ 103.45, JacFab BigMouth TB & Charge pipe, Catless downpipe, LSD diff swap, Ghetto drag pack, unfinished tune.

        Comment


        • #5
          So I think he spent a good bit. My rough math below.. I'm not sure if he gets discounts etc

          Engine harness $330
          Interior harness piece $75
          Rear harness (o2 and fuel system) $45
          Fuse &relay block $50

          Fuel pressure control module $44
          Throttle pedal $70

          So I'm pretty happy. Especially since there aren't many choices and I would need most of the pieces anyways
          Custom installation in a 1964 Lotus 7. Www.exportedafrican.com

          Comment


          • #6
            I got the harness back Tuesday and it is pretty!

            Landed up skipping the fuel controller and will let the pcm adjust as it does.

            I shot a video of it. I'm pretty happy. If you watch my other YouTube videos you can see I started tearing it apart for the motor swap!

            https://youtu.be/bTisD9vngJs
            Custom installation in a 1964 Lotus 7. Www.exportedafrican.com

            Comment

            Working...
            X